Welcome to the Web-Installer for WLED on QuinLED boards!

QuinLED-Dig-Octa

To prepare, please remove power from all boards and plug in the USB-C on the brainboard

  1. Plug in your QuinLED-Dig-Octa Brainboard using a USB-C cable to a USB port on your computer
  2. Select board version you want to flash from pull-down menu
  3. Hit "Install" and select the "USB Serial (COMx)". No device found?
  4. Custom QuinLED pre-configured WLED is installed within 3 minutes!

Because of GPIO pins used WiFi configuration needs to be done using WLED-AP (password: wled1234)
If you use ethernet, when the flashing is complete, ethernet will become active after a power cycle.

If you wish to download a custom .bin file for OTA flash, you can find them here






If you install the temperature sensor version, please follow these steps after the install:

  1. Go to Usermods
  2. Enter 32 for SDA and 13 for SCL under "Global I2C GPIOs (HW)"
  3. Tick "Enabled" under "SHT Temperature & Humidity Sensor"
  4. Hit Save
  5. Temperature and humidity will show up under "Info" after 30s and refresh every 30s
  6. If you want to use the sensors in HA, tick the "Add-To-Home-Assistant-MQTT-Discovery" box and save. HA should instantly find it and add the entities (if you have an MQTT broker configured in WLED)

Powered by ESP Web Tools
And a huge thank you to WLED